腳手架搭設方案方案示例3.doc
進入下載頁
邯鄣市供電公司用電生產樓
懸挑式腳手架搭設方案
施工單位：中國華治建設公司
1、 編制依據（略）
2、 工程概況：
本工程為邯鄣供電公司用電生產樓，位于中華大街與朝陽路交匯處，總建筑面積17747.8m2，地上十層、局部十一層，裙房四層，地下二層，建筑總高度44 m，結構形式為框架結構，本工程外架采用挑梁式雙排挑外腳手架，分別于一層、五層九層設置挑梁。里腳手架采用滿堂架了。
3．腳手架構配件的質量標準
�。�1）鋼管：鋼管一般采用外役48mm，壁厚3.5mm的3號鋼焊接鋼管，
其化學成份與機械性能符合國家標準《碳素結構鋼》（GB／T700）的要求。立桿、縱向水平桿（大橫桿）的鋼管長度一般為4~6m，橫向水平桿（小橫桿）一般為1.9~2.3m。鋼管應涂
Han Zhang F, Power Companies in electricity production
Cantilevered Scaffolding program
Construction Unit: China and China Construction Company Governance
1, prepared according to (slightly)
2, Project Overview:
This works for Han Zhang electricity production building supply company located in China Street and Chaoyang Road Interchange, the total construction area of 17747.8m2, ground 10 floor, local 10 level, four-storey podium, basement level, total building height 44 m, the structure forms the framework structure, the works stand with roof beam scaffolding outside the double challenge, respectively, layer, five-storey set the cantilever beam. Where scaffolding had with Full Frame.
3. Scaffolding components and parts quality standards
(1) Pipe: Steel pipe commonly used Statute of 48mm, wall thickness 3.5mm to 3 steel welded pipe,
Its chemical composition and mechanical properties of the national standard "carbon steel" (GB/T700) requirements. Pole, vertical horizontal bar (large bar) of the pipe length is usually 4 ~ 6m, lateral horizontal bar (small bar) is usually 1.9 ~ 2.3m. Steel should be coated