六、鋼筋工程施工方案.doc

1.2鋼筋工程承包方式
總   包：北京××工程公司××項目經理部
鋼筋分包：××省建筑工程總公司××分公司
××省×××建筑工程公司
1.3施工條件
加工場地布置在現場南側，見總平面布置（圖略），相關二級電箱布置到加工場，見臨電布置圖（圖略）。
1.4生活條件
總包方負責提供分包方工人居住、生活場地，交通電分包方自行負責。
2、施工總體安排
2.1施工準備
2.1.1測量準備
根據平面控制網，在防水保護層上放出軸線和基礎梁、墻、柱位置線；底板上層鋼筋綁扎完成后工地測量人員必須組織測放墻、柱插筋位置線（每跨至少兩點用紅油漆標注）。
頂板砼澆注完成，支設豎向模板前，在板上放出該層平面控制軸線。待豎向鋼筋綁扎完成后，在每層豎向鋼筋上部標出標高控制點。
2.1.2機具準備
（1）剝肋滾壓直螺紋機械連接機具
1.2 RC Engineering Contract
Total Package: Beijing × × × × Engineering Division Project Manager
Steel sub: × × × × Branch Province Construction Engineering Corporation
× × × × × Provincial Construction Engineering Corporation
1.3 Construction Conditions
Processing site layout at the scene south, see the general layout (figure omitted), related to the secondary power processing box layout, see Layout of temporary power (Figure omitted).
1.4 Living conditions
The total package will be responsible for providing sub-side workers to live, live venues, transport electricity sub-side themselves.
2, the overall arrangements for construction
2.1 Construction of preparation
2.1.1 Measurement preparation
According to horizontal control network, in a waterproof protective layer on the release and the foundation beam axis, wall, column line of position; bottom after the completion of the upper steel banding site measurements must measure up the wall tissue, column Reinforcing line of position (at least two points each with a red cross paint mark).
Note roof Tongjiao complete set of vertical template support, before release of the layer plane in the on-board control axis. Vertical steel banding to be completed, the vertical reinforcement at each control point elevation of the upper mark.
2.1.2 equipment ready
(1) peel rolled straight thread connection equipment
 

前往下載